The Nolan-engineered joist repair system
One versatile steel strap system repairs qualifying holes, notches, cuts, and other localized damage in solid-sawn floor joists.
Stop searching for a different repair plate for every problem. Choose the Nolan Joist Repair Kit length that provides the required reach beyond the damaged area.
Installed Nolan Joist Repair Kit
One product—not four separate repairs
Other repair products may require you to identify the exact damage type and purchase a different plate for each condition. The Nolan Joist Repair Kit uses one consistent engineered strap system for qualifying holes, notches, plumbing cuts, and other localized damage in solid-sawn floor joists.
For qualifying damage and installation conditions within the current Nolan design criteria. Strap length changes to suit the condition; the repair system remains the same.
View Nolan JRK OptionsOne consistent approach
The damage may look different, but the repair principle remains the same: bridge the weakened area and transfer tension back into qualifying sound wood.
Designed for qualifying drilled, cut, notched, and otherwise weakened solid-sawn joists.
Use the same Nolan strap system instead of shopping for a different plate for each type of damage.
Select the length that reaches far enough beyond the damage to develop the required connection.
Backed by current design, installation, and sizing documents for qualifying conditions.
Start with the Nolan system
The repair system stays consistent. The strap length changes to suit the qualifying damage dimensions, required connection into sound wood, and nearby obstructions.
$59.99
View Kit → Nolan-engineered
$69.99
View Kit → Nolan-engineered
$79.99
View Kit → Nolan-engineered
$94.99
View Kit →Engineering and installation
Confirm that the existing joist, damage, strap length, and installation conditions fall within the current Nolan Joist Repair Kit criteria.
Alternative plates sized for a particular solid-sawn joist and qualifying round-hole condition.
Alternative plates sized for a particular solid-sawn joist and qualifying notch condition.
A separate repair approach for qualifying cracks, splits, or localized damage in dimensional-lumber joists.
Engineered I-joists are not solid-sawn lumber. Use a web-specific product when the condition fits its criteria.
Top- or bottom-flange damage requires a flange-specific solution or applicable project engineering.
An end-support bracket addresses qualifying bearing conditions; it is not a midspan hole or notch repair.
Joist repair FAQ
The Nolan system is intended for qualifying holes, notches, cuts, and other localized damage in solid-sawn dimensional-lumber floor joists. The existing joist and damage must satisfy the current design and installation criteria.
Compare the damage dimensions, required connection into sound wood, nearby utilities, and the specific guidance for the available strap lengths. Joist depth alone does not determine strap length.
For qualifying solid-sawn floor-joist conditions, the same Nolan strap system can address drilled, cut, and notched damage. Confirm the condition and required strap length against the current product documents before ordering.
Not under the standard solid-sawn-joist application. I-joist web and flange damage require the corresponding I-joist product or applicable project-specific engineering.
Provide the joist type, actual depth, span, damage size and location, remaining wood, spacing, nearby utilities, and clear wide and close-up photographs.
No. Suitability depends on the existing member, damage, loading, and installation access. Conditions outside the published criteria may require project-specific engineering or another repair approach.
