I-Joist Flange Notch Reinforcers (Patent Pending) are designed for Engineered I Joist Repairs that require reinforcement due notch cuts in the I-Joist Flange and down into the web. The series number (150/250/350) refers to the width of the flange or cord at the top and bottom of the iJoist. i-Joists with notch cuts up to 6" wide and 4" deep can be reinforced to 100%+ original load bearing capability. Nearly all i-Joist manufacturers conform to the common i-Joist heights of 9 1/2", 11 7/8", 14" and 16 or Reinforcers accomodating all popular brands such as TJI, LP, BCI, and all others that conform to typical i-Joist sizes.
Reinforcers are made of 10 gauge galvanized steel, which makes them the strongest Reinforcers made.
1 1/2" Overall flange width
2 1/2" Overall flange width
3 1/2"Overall flange width
Joist Sizes:
Plate thickness: 10Ga
Plate width: 23.75"
Nominal iJoist Height of 9 1/2", 11 7/8", 14" and 16"
All series and dimension I-Joist Reinforcers accommodate a 5" wide x 3.25" deep notch commonly required for an offset toilet flange, but will allow the passage of any utility less than 3.25".
Fits all major brand I-Joists, including, but not limited to the following:
Great solution to my 100 yr old 1st floor deflection issues. Numerous MEP obstacles made sistering the old joists inefficient. A bit of drilling/screwing but well worth it.
It is a good product. Well made pre-drilled and structural screws with it. Price was ok little high than I was hoping but I understand testing and all that. I will shop here again if I run into this situation again. Thank you
